Services
- Design, dimensioning and analysis of power electronic and electronic circuits
- Modeling and simulation of power electronic components and assemblies
- Investigations in the field of electrical drives technology
- Pre-Compliance-Tests
- Thermal analysis
Laboratory Equipment
- Grid simulation systems for any voltage waveform up to 30 kW three-phase (Spitzenberger & Spies EMV D 30000/PAS and EMV D 15000/PAS)
- Motor Drive Analyzer for transient power analysis (Teledyne LeCroy MDA 8108HD, 8 channels, 12 bit, 1 GHz, 10 GS/s)
- Bidirectional DC power supply with battery simulation up to 1000 V / 40 A / 15 kW (EA-PSB 91000-40)
- Test benches for electrical machines up to 36 kW @ 5000 min-1 / 230 Nm @ 1500 min-1
- Precision power meters (ZES LMG500 und LMG450)
- Power Scope for transient power analysis (Yokogawa PX8000)
- 12 Bit oscilloscopes (Teledyne LeCroy Waverunner HRO 66Zi and MDA based on Waverunner 8000HD)
- Various dSpace rapid prototyping development systems or HIL test systems on µC and FPGA basis
- Modular multiplex measurement system (Keithley DAQ6510 with currently 20 channels)
- Thermal imaging camera Micro-Epsilon TIMQVGA-HD
- Precision current transformers in various configurations
- Various data acquisition systems from National Instruments
- Vibration analysis system (with Ono Sokki DS-2100 and calibration system from MMF)
- EMV-Messplatz für leitungsgebundene Netzrückwirkungen bis 30 MHz
- Radio interference measuring receiver (Rohde und Schwarz ESPC)
- EMC surge and burst generator (Hilo CE tester with CDN4416 coupling network)
- Environmental simulation cabinet (CTS)
- PCB placement machine (Fritsch PA510)
- PCB prototyping (LPKF ProtoMat S62)
- Prototyping reflow oven (LPKF ProtoFlow)
- Various µC development workstations (e.g. TI C2000 real-time systems)
- Software for model-based development (MATLAB/Simulink with corresponding toolboxes)
- Software for numerical field calculation (ANSYS Maxwell)
- Software for system simulation (Adapted Solutions Portunus)
and much more ...
Use of Laboratory Infrastructure
For questions regarding the use of the laboratory infrastructure, please contact:
Prof. Dr.-Ing. Christian Schumann